This case presents an analysis using Cadpress for an automotive radiator support. The figure on…
The Madison GroupOctober 1, 2022
This case study examines why a plastic lawn mower wheel hub failed while in service,…
The Madison GroupSeptember 10, 2022
The Problem A customer wanted to identify the process sensitivity of a polyethylene injection-molded container.…
The Madison GroupSeptember 1, 2022
What Went Wrong? The fuel filter in a gasoline engine application was leaking while in…
The Madison GroupAugust 2, 2022
What Went Wrong? The actuating levers on a high number of medical components cracked after…
The Madison GroupJuly 29, 2022
What Went Wrong? A plastic rain barrel was cracking at the bottom of a stiffening…
The Madison GroupJuly 1, 2022
What Went Wrong? A section of tubing was submitted for evaluation as the material had…
The Madison GroupJune 1, 2022
What Went Wrong? An injection-molded acetal shroud used in a medical device assembly was experiencing…
The Madison GroupJune 1, 2022
The Problem An injection molder needed to determine the feasibility of using a co- injection…
The Madison GroupMay 20, 2022